slip joint

In the jointed fractured rock mass, the instability of tunnel is always because the blocks slip along the joint surface.

在节理破碎岩体中，隧道的失稳破坏往往是由于岩块沿节理面的剪切滑移造成的。

Tangential contact stress and slip distance on the wall of the top of window, junction of vertical and horizontal wall and lower right corner of door, where mortar joint cracks easily, are the largest.

门窗上边的墙体、纵横墙连接处、门右下角的接触切向应力以及砌块之间的滑移最大，灰缝容易从此处开裂。

Engineering Calculation of Forming Pressure on Cross Wedge Rolling for the Blank of Slip Joint Pliers

鲤鱼钳毛坯楔横轧成形压力的工程计算

There must be one or more universal joints to permit variations in the angle of drive. There must also be a slip joint that permits the effective length of the propeller shaft to change.

可轴向移动的球笼式万向节一个或几个万向节来适应传动角度的变化；一套伸缩花键，能够改变传动轴的现有长度。

Lower the slip joint and fix its top connector into the diverter.

下放伸缩隔水管,将伸缩隔水管顶部接头安装到转喷器壳体上.

The slip spheric joint support is also used for the large-span steel structure roofing in order to dispel distortion by temperature change an.

为了消除温度变形和安装允许误差的影响，对大跨度钢结构屋面在支座部位采用了滑动球铰支座。

Remove the high pressure choke and kill hoses from the slip joint.

从伸缩节上卸开高压放喷和压软管。

Cross Wedge Rolling Preforming Technology and Die Design of Slip Joint Pliers

锂鱼钳楔横轧制坯工艺及模具设计

Modeling and Simulation of Pneumatic and Hydraulic Underwater Weapon Launching System Lower the slip joint and fix its top connector into the diverter.

气动水压式水下武器发射系统建模与仿真下放伸缩隔水管，将伸缩隔水管顶部接头安装到转喷器壳体上。

The productive process of performing forming roll forging technology of slip joint pliers is introduced.

介绍了锂鱼钳制坯一成形辊锻工艺的生产过程.

Connect the choke and kill lines to slip joint.

将放喷和压井胶管与伸缩节连通.